---
crowd-funded eco-conscious hardware: https://www.crowdsupply.com/eoma68
Post by shraptorI want to back the computer card crowd funding.
I saw you were fiddling with Devuan and want to know if there is gonna
be a "Devuan" computer card to back in the near future?
there will - i'll be adding it in a couple of days, i have a stack of
"updates" ready to go, but we can't do them all at once :) if you
prefer you can get a libre tea and change it later (contact
Post by shraptorI am interested in the laptop housing but that is at another price bracket.
well at least you'll have the computer card, that's the critical
thing, we need to reach a MOQ of 250 units on that. pricing will come
down later once we reach mass-volume, so you'll be able to get it much
cheaper in a couple of years, if that helps at all.
Post by shraptorI am not familiar with 3d printing and could you give an estimate what would
a laptop case cost to print at a local shop?
tell them that there's approximately 25 metres of 3.0mm PLA, that you
can use up to a 0.4mm nozzle and that a 0.15mm layer height is fine,
and they'll be able to give you a quote. but DO NOT get the "cheap"
PLA - the stuff we know works is from Faberdashery, it's very high
quality and very strong.
if they really really can't get decent very high quality PLA, then if
they can do PolyCarbonate or Nylon for the hinge parts left and right
(which are small, only about 0.15 metres of 3.0mm filament) then you
should be good.
Post by shraptorI guess then there is wiring and stuff todo after printing, right?
yeahhhh, it's on the questions on the page, i will be documenting the
assembly to *beyond* the level that chris palmer did his instructions
for the mendel90.
l.
Post by shraptor/scooby
_______________________________________________
http://lists.phcomp.co.uk/mailman/listinfo/arm-netbook
_______________________________________________
arm-netbook mailing list arm-***@lists.phcomp.co.uk
http://lists.phcomp.co.uk/mailman/listinfo/arm-netbook
Send large attachments to arm-